What's up with the Nepal earthquake?
On April 25, an earthquake measuring 7.8 on the Richter scale struck Nepal near its capital, Kathmandu. The country’s general underpreparedness for quakes together with flimsy public infrastructure resulted in the loss of over 6,600 lives (at last count; May 2). But the root of the blame lay with the Nepali and Indian governments’ inexplicable blindness toward the possibility of megaquakes in the region, which geologists from around the world have warned of since a decade. While India continues to plan hydroelectric projects in the region, Nepal has few quake-proof shelters, not to mention buildings that that can barely withstand one.
The scale of the disaster – with some projecting the eventual loss of life to hover around 10,000 – will serve as a shrill wake-up call. Aside from comparisons to the quake that ripped through Port au Prince in 2010, policymakers now have a sordid number to place on the cost of overestimating the Himalayan region’s geologic stability. People in the region will also likely (rather, hopefully) pay more attention to geologists, for whom this earthquake is both a tragic I-told-you-so moment as well as a call to study further one of the world’s most prominent yet poorly understood seismological hotspots.
The quake’s origins can be traced to the Indian tectonic plate crashing into the Eurasian plate. Since the late 1980s, geologists have agreed that before the crash, the Indian plate was moving almost twice as fast as the other plates were for about 20 million years, at 140 mm/year, for over 6,000 km. Some 40-50 million years ago, the Indian plate rammed into the Eurasian plate, folding upwards and creating the Himalayas. The aggressive collision continues to this day, with India moving into Asia at 67 mm/year, pushing up the Himalayas at 5 mm/year. The tensions building up in the rock as a result keep the Himalayan range geologically active, with earthquakes as means to relieve the stresses.
Of particular concern is the central seismic gap, which runs northeast of Delhi along a region woven with unstable faults and including over 10 million people. Until April 25, observers had been concerned by the paucity of earthquakes in the gap: the longer there were no quakes, the more the pent up stresses, and the stronger a future quake will be. In February 2015, Priyanka Pulla had reported in Science that an earthquake that occurred in the CSG in 1505 could’ve been weaker than thought, further intensifying the chances of a “megaquake” in the future. One finally came to be near Kathmandu, and it likely won’t be the last.
The key to predicting future quakes, their occurrence patterns and locations will be to understand the structure and behavior of the earth below the Himalayas and – farther back in time – reconstructing a seismological history of the subterranean volume of rock.
A paper from March 12, 2015, from a team of researchers from India and Australia in the journal Lithosphere, attempts to answer the former question, describing the “spatial distribution of the rock uplift” in the western 400 km portion of the CSG. The researchers write,
Although the vulnerability of this region to large earthquakes has been identified for quite some time, the active structures that could potentially host a large seismic event remain poorly understood across much of the central seismic gap, particularly within the western half of the gap that spans the state of Uttarakhand, India. Since earthquake magnitude relates to rupture area, and therefore is a function of fault geometry, understanding which fault segments have accommodated slip over time scales of 1,000–10,000 yr is relevant to assessing where rupture might occur next in this region of the Himalaya and how large such an event could be.
The team’s conclusion describes an active thrust fault below Uttarakhand pregnant with enough tension to unleash a quake measuring at least 8 on the Richter scale. This, in a state already prone to crippling landslides and floods, and with 70% of its population (of about 10 million) residing in rural areas. They attribute the tremendous tension to a geometry of rock that has partially separated from a layer beneath and caused folds and deformations. The technical term for this geometry is a décollement:
the landscape and erosion rate patterns suggest that the décollement beneath the state of Uttarakhand provides a sufficiently large and coherent fault segment capable of hosting a great earthquake.
The answer to the second question – of how the Indian plate rammed into the Eurasian plate harder than usual – is what a team of researchers from MIT and the University of South California have taken a shot at in the May 4 issue of Nature Geoscience. The team uses numerical simulations to describe a scenario in which the Indian plate could’ve been actively pulled into the Eurasian plate as if its motion was lubricated by smoother mantle flow, over which our planet’s tectonic plates slide.
According to their tests, there could’ve been three plates – call them A, B and C – colliding near the Eurasian plate such that A was slipping under B and B was slipping under C. This double subduction zone formed a pipe-like volume beneath the subducted parts of A and B through which the flow of mantle was squeezed (see image). Evidently, the mantle flow would have been slower if A and B had been long (~10,000 km long) and closer together.
However, numerical simulations run by the team showed that if A and B had been shorter (~3,000 km long) and farther apart, the mantle flow through the pipe-like volume would’ve been fast enough to cause a drop in pressure underneath and pull the incoming Indian plate. And, according to Oliver Jagoutz, from MIT’s Department of Earth Atmospheric and Planetary Sciences, and his team, this is what could’ve happened – between the Indian plate (A), the Kshiroda plate (B) and the Eurasian plate (C).
The paper reads,
The model yields slow initial convergence at ∼40 mm/yr [until ~120 Myr], because viscous pressure is very high between slabs with a trench-parallel width of 10,000 km and young buoyant oceanic lithosphere, created at the extinct spreading ridge north of Greater India, is subducting beneath the Trans-Tethyan subduction system. Model rates begin to increase at ∼80 Myr because trench-parallel narrowing of the Trans-Tethyan subduction system from 10,000 to 3,000 km reduces the viscous pressure between the slabs and the sea floor entering the Trans-Tethyan subduction system is ageing and becoming more negatively buoyant. The former effect dominates, producing more than three-quarters of the rate increase at 75–70 Myr.
(‘Myr’ stands for million years.)
If these results are corroborated by other studies, the double-subduction mechanism will be a new way to understand how colliding plates could interact, and if they could move faster or slower over time depending on their physical dimensions. As Magali Billen, a geophysicist at the University of California, Davis, writes of the paper in a Nature News & Views piece,
There are other known mechanisms that can lead to rapid changes in plate motion. For example, an upwelling plume head can accelerate mantle flow and an increase in slab density during initial subduction of a plate through the mantle transition zone can accelerate slab descent . However, these mechanisms lead to short-lived, one-to two-million-year pulses of accelerated plate motion. In contrast, the mechanism of double subduction can generate sustained, 20-million-year-long intervals of rapid plate motion, similar to that recorded for the Indian Plate during the late Cretaceous [145-66 Myr ago].
In the study of giant hurricanes, the Saffir-Simpson scale provides a way to measure the relative magnitude of each storm. However, the scale has been calibrated on the basis of storms that have already occurred, and it’s not beyond nature to unleash a storm in the future that breaks the scale. Similarly, there haven’t been enough earthquakes logged in record books to know how many make a pattern, how much is too strong, or if there are time-bound ways to accurately predict earthquakes*. Without these patterns, geologists may accrue a vast body of knowledge yet still not come into a position to predict the time of the next earthquake and its probable magnitude in term for precautionary measures. As the noted geophysicist Roger Bilham wrote in the Annals of Geophysics (PDF) in 2004,
Perhaps the most disappointing observation is that despite a written tradition extending beyond 1500 B.C. we know very little about Indian earthquakes earlier than 500 years before the present, and records are close to complete only for earthquakes in the most recent 200 years. This presents a problem for estimating recurrence intervals between significant earthquakes, the holy grail of historic earthquake studies. Certainly no repetition of an earthquake has ever been recognized in the written record of India and the Himalaya, although great earthquakes in the Himalaya should do so at least once and possibly as much as three times each millennium.
Studies like the two discussed in this post, among a larger body of thousands like them, together allay this significant uncertainty. The Geoscience paper about double-subduction provides the sort of insights into plate tectonics that seismologists could use to describe the long-term behaviors of landmasses and their impact on natural resources in the region. On the other hand, the Lithosphere paper about the presence of active faults under areas like Uttarakhand allow scientists as well as politicos to explore ways to combating disasters in the shorter-term. Ultimately, the goal will be to achieve a prefect union of long-term and short-term knowledge to forecast and survive future earthquakes better.
*Another paper from Nature Geoscience this week discusses the conditions under which earthquake ‘supercycles’ – cycles spanning thousands of years – could manifest.
Thanks to:
- @TheCarbuncle
- The Seismological Society of America, which opened up access to 23 papers from its two journals “to foster the exchange of information about this region, and in an effort to fulfill our goal to “advance seismology and the understanding of earthquakes for the benefit of society” from two of its journals
Featured image: Something festers… deep in the heart of Middle Earth. Credit: Wikimedia Commons
